Preparation of Tea 

The traditional method of making a cup of tea is to place loose tea leaves, either directly, or in a tea infuser, into a tea pot or teacup and pour hot water over the leaves. After a couple of minutes the leaves are usually removed again, either by removing the infuser, or by straining the tea while serving.

Most teas should be allowed to steep for about three minutes, although some types of tea require as much as ten. The strength of the tea should be varied by changing the amount of tea leaves used, not by changing the steeping time. The amount of tea to be used per amount of water differs from tea to tea but one basic recipe may be one slightly heaped teaspoon of tea (about 5 ml) for each teacup of water (200 ml) prepared as above. Stronger teas, like Assam, to be drunk with milk are often prepared with more leaves, and a more delicate high grown tea such as a Darjeeling are prepared with a little less (as the stronger mid-flavors can overwhelm the champagne notes).
The best temperature for brewing tea depends on its type. Teas that have little or no oxidation period, such as a green or white tea, are best brewed at lower temperatures between 60 °C and 85 °C (140-185 °F), while teas with longer oxidation periods should be brewed at higher temperatures around 100 °C (212 °F).

Some tea sorts are often brewed several times using the same tea leaves. Historically, in China, tea is divided into a number of infusions. The first infusion is immediately poured out to wash the tea, and then the second and further infusions are drunk. The third through fifth are nearly always considered the best infusions of tea, although different teas open up differently and may require more infusions of hot water to bring them to life.

One way to taste a tea, throughout its entire process, is to add hot water to a cup containing the leaves and after about 30 seconds to taste the tea. As the tea leaves unfold (known as "The Agony of the Leaves") they give up various parts of themselves to the water and thus the taste evolves. Continuing this from the very first flavors to the time beyond which the tea is quite stewed will allow an appreciation of the tea throughout its entire length.

Black tea

The water for black teas should be added at the boiling point (100 °C or 212 °F). Many of the active substances in black tea don't develop at temperatures lower than 90 °C. For some more delicate teas lower temperatures are recommended. The temperature will have as large an effect on the final flavor as the type of tea used. The most common fault when making black tea is to use water at too low a temperature. Since boiling point drops with increasing altitude, this makes it difficult to brew black tea properly in mountainous areas. It is also recommended that the teapot be warmed before preparing tea, easily done by adding a small amount of boiling water to the pot, swirling briefly, before discarding. Black teas are usually brewed for about 4 minutes and should not be allowed to steep for less than 30 seconds or more than about five minutes (a process known as brewing or [dialectally] mashing in the UK, specifically in Yorkshire.). Longer steeping times make the tea bitter (at this point it is referred to as being stewed in the UK). When the tea has brewed long enough to suit the tastes of the drinker, it should be strained while serving.

Green tea

Water for green tea, according to most accounts, should be around 80 °C to 85 °C (176 °F to 185 °F); the higher the quality of the leaves, the lower the temperature. Hotter water will burn green-tea leaves, producing a bitter taste. Preferably, the container in which the tea is steeped, the mug, or teapot should also be warmed beforehand so that the tea does not immediately cool down.

Oolong teas should be brewed around 90 °C to 100 °C (194 °F to 212 °F), and again the brewing vessel should be warmed before pouring in the water. Yixing purple clay teapots are the traditional brewing vessel for oolong tea. For best results use spring water, as the minerals in spring water tend to bring out more flavors in the tea. High quality oolong can be brewed multiple times from the same leaves, and unlike green tea it improves with reuse. It is common to brew the same leaves three to five times, the third steeping usually being the best.

Premium or delicate tea

Some teas, especially green teas and delicate Oolong or Darjeeling teas are steeped for shorter periods, sometimes less than 30 seconds. Using a tea strainer separates the leaves from the water at the end of the brewing time if a tea bag is not being used. Elevation and time of harvest offer varying taste profiles, proper storage and water quality also plays a large impact on taste.

Pu-erh tea (or Pu'er)

Pu-erh teas require boiling water for infusion. Some prefer to quickly rinse pu-erh for several seconds with boiling water to remove tea dust which accumulates from the aging process. Infuse pu-erh at the boiling point (100 °C or 212 °F), and allow to steep for 30 seconds or up to five minutes.

Serving
In order to preserve the pre-tannin tea without requiring it all to be poured into cups, a second teapot is employed. The steeping pot is best unglazed earthenware; Yixing pots are the best known of these, famed for the high quality clay from which they are made. The serving pot is generally porcelain, which retains the heat better. Larger teapots are a post-19th century invention, as tea before this time was very rare and very expensive.

Experienced tea-drinkers often insist that the tea should not be stirred around while it is steeping (sometimes called winding in the UK). This, they say, will do little to strengthen the tea, but is likely to bring the tannins out in the same way that brewing too long will do. For the same reason one should not squeeze the last drops out of a teabag; if stronger tea is desired, more tea leaves should be used.

Adding milk to tea

The addition of milk to tea was first mentioned in 1680 by the epistolist Madame de Sévigné. Many teas are traditionally drunk with milk. These include Indian chai, and British tea blends. These teas tend to be very hearty varieties which can be tasted through the milk, such as Assams, or the East Friesian blend. Milk is thought to neutralize remaining tannins and reduce acidity.

The order in which to make a cup of tea is a much-debated area. Some say that it is preferable to add the milk before the tea, as the high temperature of freshly brewed tea can denature the proteins found in fresh milk, similar to the change in taste of UHT milk, resulting in an inferior tasting beverage.

Others insist that it is better to add the milk after brewing the tea, as most teas need to be brewed as close to boiling as possible. The addition of milk chills the beverage during the crucial brewing phase, meaning that the delicate flavor of a good tea cannot be fully appreciated. By adding the milk afterwards, it is easier to dissolve sugar in the tea and also to ensure that the desired amount of milk is added, as the color of the tea can be observed.

In Britain and some Commonwealth countries, the order in which the milk and the tea enter the cup is often considered an indicator of social class. Persons of working class background are supposedly more likely to add the milk first and pour the tea in afterwards, whereas persons of middle and upper class backgrounds are more likely to pour the tea in first and then add milk. This is said to be a continuing practice from a time when porcelain (the only ceramic which could withstand boiling water) was only within the purchasing range of the rich - the less wealthy had access only to poor quality earthenware, which would crack unless milk was added first in order to lower the temperature of the tea as it was poured in.

A recent medical study found that certain beneficial effects of tea are lost through the addition of milk.

Other additives

Other popular additives to tea include sugar or honey, lemon, fruit jams, mint. In colder regions such as Mongolia, Tibet and Nepal, butter is added to provide necessary calories. Tibetan butter tea contains rock salt and dre (yak) butter, which is then churned vigorously in a cylindrical vessel closely resembling a butter churn. The flavor of this beverage is more akin to a rich broth than to tea, and may be described as an acquired taste to those unused to drinking it. The same may be said for salt tea, which is consumed in some cultures in the Hindu-Kush region of northern Pakistan, and probably in other areas as well.

The flavor of the tea can also be altered by pouring it from different heights, resulting in varying degrees of oxidizations. The art of high-altitude pouring is used principally by people in Northern Africa (e.g. Morocco), but also in West Africa (e.g. Guinea, Mali, Senegal) and can positively alter the flavor of the tea, but it is more likely a technique to cool the beverage destined to be consumed immediately, often cooked with mint leaves. In certain cultures the tea is given different names depending on the height it was poured form.

In Mali, gunpowder tea is served in series of three, starting with the highest oxidization or strongest, unsweetened tea (cooked from fresh leaves), locally referred to as "bitter as death". Follows a second serving, where the same tea leaves are boiled again with some sugar added ("pleasant as life"),and a third one, where the same tea leaves are boiled for the third time with yet more sugar added ("sweet as love"). Green tea is the central ingredient of a distinctly Malian custom, the "Grin", informal social gathering that cuts across social and economic lines, starting in front of family compound gates in the afternoons, extending late in the night and widely popular in Bamako and other large urban areas.

In Southeast Asia, particularly in Malaysia and Singapore, the practice of pouring tea from a height has been refined further using black tea to which milk and usually sugar has been added, being poured from a height from one cup to another several times in alternating fashion and in quick succession, to create a tea with entrapped air bubbles creating a frothy "head" in the cup. Expert practitioners of this skill, usually in community hawker food stalls, are a pleasure to watch, a kind of street performance art that adds to the enjoyment of the drink. This beverage, teh tarik, literally, "pulled tea", has a creamier taste than flat milk tea and is extremely popular in the region. Tea pouring in Malaysia has been further developed into an art form in which a dance is done by people pouring tea from one container to another, which in any case takes skill and precision. The participants, each holding two containers, one full of tea, pour it from one to another. They stand in lines and squares and pour the tea into each others' pots. The dance must be choreographed to allow anyone who has both pots full to empty them and refill whoever has no tea at any one point. They are full of rhythmic patterns and a joy to watch.

Check out http://tropicalteaco.blogspot.com for updated news on Tropical Tea Company and daily Thought Of the Moment (TOM).